Physical Level/Lower level protocols

When the protocol was designed it’s usefulness on the CAN bus was the main objective. The identifier length and many other things on Level I are therefore very “CAN-ish” in its design and behavior. CAN is however no prerequisite. The protocol works equally well over RS-232, RF-Links, Ethernet etc.

Level I is effective over bandwidth limited links but don't have the full GUID of the nodes in the frames and some sort of lower level addressing system must be used.

VSCP over CAN
VSCP over Serial Links
VSCP over RS-485
VSCP over Ethernet
VSCP over TCP/IP
VSCP over RF and PLC
VSCP over MiWi, 802.15.4